What are the steps to replace the oil seal of the reducer?

During the long-term use of the reducer, the oil seal needs to be replaced from time to time to ensure the normal operation of the reducer. The following is a brief introduction to the basic steps of replacing the oil seal of the reducer.

1. Remove the fan cover and fan

2. Remove the end cap and the oil seal that needs to be replaced

3. Clean the joint surface sealant and deal with the isolation

4. Treat the input shaft oil seal until smooth and without marks

5. Apply a small amount of butter to the outer ring of the new oil seal and install it in place with a flat iron plate

6. Apply a small amount of butter to the lip of the oil seal, and apply sealant to the joint surface

7. When installing the end cap, ensure that the oil passage hole position of the oil passage hole end cap is consistent

8. Confirm whether the oil seal has a reverse lip phenomenon, and tighten the end cover bolts

The above are the steps for replacing the oil seal of the geared motor shared by Vshida Micromotor. I hope it will be useful to you. For more information, please feel free to consult us.