Steps for installing planetary gear motor

The secret to proper operation of planetary gear motors is careful installation and maintenance. Therefore, when installing a planetary gear motor, you must follow the installation procedures precisely. Specific instructions for installing a planetary gear motor are as follows.

Step 1: Prior to installation, ensure that the drive motor and planetary gear motor are in good condition and that you strictly verify that the dimensions of all components associated with them are accurate. This refers to the dimensions between the positioning bosses and shaft diameters of the drive motor flange and the positioning recesses and apertures of the geared motor flange, as well as the cooperative metric service; wipe the dirt and burrs from the cooperative surface.

Step 2: Fix the bolts to the process holes on the side surface of the planetary gear motor flange. Then, rotate the input end of the gear motor to align the hexagonal screw cap with the process hole.

Step 3: Insert the shaft of the handheld drive motor into the input end hole of the planetary gear motor so that the keyway on the motor shaft is perpendicular to the clamping screw on the hole. When piercing the hole, you must make sure that the two flanges are parallel and concentric. If the flanges on both sides are not parallel and have different concentricity, the reason must be identified. In addition, it is absolutely forbidden to strike with a hammer during installation to prevent excessive damage to both bearings and to ensure compatibility. It is important to evaluate the installation according to the hand feeling. The way to judge the concentricity of the two cooperation and flange parallelism is that the two are stabbed into each other after the two flanges are completely tight and the gap is the same.

Step 4: Drive the motor first tighten the screws, but do not tighten; then gradually tighten the four fastening screws according to the diagonal position; finally tighten the end screws of the input end hole of the geared motor. Note that before tightening the input end hole and screws of the geared motor, tighten the fastening screws of the drive motor first. Remember that the proper installation of the planetary gear motor and mechanical equipment is the same as the installation of the gear motor and drive motor. The key is to make sure that the input shaft of the driven part and the output shaft of the geared motor are concentric.

The above is to introduce you to the installation steps of planetary gear motor, I hope it will help you, more related information please continue to pay attention to Vshida micro motor