Home - Products - Gear Motor - Details
12V 24V Right Angle BLDC Gear Motor For Valve Actuator Pump
video
12V 24V Right Angle BLDC Gear Motor For Valve Actuator Pump

12V 24V Right Angle BLDC Gear Motor For Valve Actuator Pump

Space, not power A valve actuator in a die-cast body usually has no room behind the stem. That constraint, more than torque, is what this motor was drawn for. The output leaves the gearbox at ninety degrees to the motor, so the Ø24 mm body sits beside the load instead of behind it. Only...

Description

Space, not power

A valve actuator in a die-cast body usually has no room behind the stem. That constraint, more than torque, is what this motor was drawn for.

The output leaves the gearbox at ninety degrees to the motor, so the Ø24 mm body sits beside the load instead of behind it. Only the rectangular box crosses the shaft line. It costs a housing that measures 32 mm by 25.5 mm rather than offering a clean bolt circle, and it fixes the orientation: one flat face to land on, not four ways round. Settle which side the cable exit belongs on before the plate is cut, because there is no second chance to rotate it afterwards.

Four M3 threads on an 18 mm by 14.8 mm rectangle hold it down. The shaft stands 19.5 ±0.45 mm clear of the box face, and the whole assembly runs 76 ±0.5 mm, with a 30 mm motor section on a Ø24.2 mm can.

What the bench says

Two windings are catalogued, both measured on the same gearbox.

Winding Supply range No load Maximum efficiency point Starting
12 V nominal 8–16 V DC 25 rpm at 0.09 A 19 rpm at 0.313 A, 437.936 mN·m, 0.891 W 1962 mN·m at 1.09 A
24 V nominal 18–26 V DC 50 rpm at 0.087 A 42 rpm at 0.426 A, 692.477 mN·m, 3.028 W 4100.58 mN·m at 2.096 A

Both are slow by design. The reduction carries the job and the motor turns close to where it runs happiest, which is why the output sits in the tens of rpm rather than the hundreds. Standing current is low enough that a pack left connected between cycles will not drain noticeably. Inrush is another matter and runs several times the running figure, so size the driver against the starting column. A supply picked from the middle one will fault the first time it meets a stiff stem.

Mass and ingress protection have not been published for this frame, so they stay blank here.

Choosing between them

Take the slow winding if the mechanism only has to close, hold and release. Take the faster one if the same actuator has to finish a cycle inside a set time, since the extra speed arrives without a second reduction stage.

Ratio, shaft, lead length and exit, connector and mounting holes are all drawn to order. Send the shaft speed, the torque needed there and the supply you have, and we will size against those three numbers rather than against a ratio chart. Electric valves, powered tools, portable screwdrivers, air and water pumps, small appliances, automotive actuators and intelligent hardware are where this frame usually lands.

Tell us early if the load can back-drive the output.

You Might Also Like

Shopping Bags