What to do if the motor is worn out

Equipment failure is often encountered in the industrial production process. If you know some simple fault diagnosis methods and maintenance knowledge, you will reduce a lot of losses in the work. Below is a brief introduction to the causes and solutions of motor wear.

1. The motor has more or less failures after long-term use. The main manifestation of this phenomenon is increased vibration and noise. The main reason for this phenomenon is that the components in the chassis are badly worn or damaged.

2. Parts that are often damaged: gear wear, gear breakage, gear shaft hole or keyway wear; the screw hole at the bearing hole is easy to fail due to wear; due to long use, the shaft surface and keyway are also easy to wear.

3. Maintenance method:

(1) Professional and technical personnel are required for maintenance, but for large equipment, maintenance points can be found to repair parts, which will greatly save the overall cost of users.

(2) If it is due to the wear of the shaft hole keyway on the surface of the DC gear motor shaft, the original accuracy of the parts can be restored by electroplating.

(3) If the gear teeth of the reducer are broken and damaged, new parts need to be reworked. In order to ensure the service life of the hardened gear reducer, it is necessary to select a good model when purchasing a DC geared motor, ensure the safety factor of the reducer, and operate in strict accordance with the instructions to give full play to the maximum effect and maximum use efficiency of the geared motor.

The above is an introduction to the reasons for the wear and tear of the DC geared motor. If the use time is too long, it will inevitably lead to failure. Therefore, it is necessary to choose an appropriate method to improve the work performance and quality, and avoid unnecessary losses caused by blind operation.