What should I do if the gear motor is blocked?

Micro DC geared motor is a common type of motor, which is recognized by everyone for its good performance and wide application range. After long-term use, the problem of motor blockage will often occur. Serious blockage will damage the motor and affect the normal operation of the equipment. The following is a brief introduction to the protection of the interruption method of the DC geared motor.

1. Ensure the safe operation of the equipment

The catalyst must be injected in a specific ratio and the residence time cannot be too long, otherwise problems such as reduced motor viscosity and reduced product quality will occur. Appropriate safety measures should be taken to ensure the smooth and normal operation of the DC geared motor.

2. Regularly replace lubricating oil and wear parts.

The main internal parts of the engine are worm, worm gear, slider, piston, etc. The wear of these parts will automatically reduce the engine flow. The solution is to regularly replace the lubricating oil, wear parts and clean the hydraulic chamber.

3. Strict workflow

The startup and shutdown process should strictly follow the operational requirements. When the motor starts, it runs with zero power. Only when the DC gear motor outputs a certain pressure, can the voltage stabilizer plate be filled with nitrogen. Nitrogen filling can prevent significant deformation of the coating and prevent the coating from cracking; when increasing the motor power, it should be done slowly; when the motor is stopped, its power should also be slowly decreased.

4. Strengthen engine maintenance

Periodically check the oil lubrication level, engine noise, exhaust pressure, nitrogen buffer tank pressure, etc. during the operation of the geared motor. Regularly replace the engine block diaphragm and nitrogen buffer tank diaphragm to effectively prevent the occurrence of catalyst stoppage accidents caused by simultaneous damage of the two motors.

In summary, in the daily use of the geared motor, it is always necessary to ensure the safe operation of the equipment, regularly replace the lubricating oil, strictly follow the standard operating schedule, and strengthen maintenance. I hope that the four methods to avoid the blockage of the geared motor introduced above will help you in the use of the geared motor in the future.