What are the causes of broken wires in motor winding machines?

Motor winding machines are usually used with various problems, especially when used for a longer period of time. The following describes the three most common causes of wire damage in motor winding machines.

1. Hardware problems cause broken wires

Broken wires are caused by common problems such as tensioner failure, wire storage ring problems, burrs around the wire and card problems. Broken wires can also be caused by insufficient lubrication.

2. Setup problems cause broken wires

Regarding wire breakage, typical setup problems are too high winding speed, tension is not set according to the tension correspondence table, and wire diameter is not properly adjusted and does not match the tension. It all boils down to operating and setting the motor winding machine in accordance with the safety operating procedures.

3. The material itself causes the broken wire

The main problem with the material is the wire. It may be because a large wire is used for a small diameter wire, resulting in a mismatch between the tension and the strength of the motor winding machine; it may also be because the wire itself is of substandard quality.

The above is the Vshida micro-motor on the motor winding machine broken wire reasons, for further information, please feel free to contact us.